Epson Stylus TX111 - Page 97

Epson Stylus NX100/105/SX100/105/TX100/101/102/103/105/106/109/ME 300/ME OFFICE 360/NX110/115/SX110/115/TX110/111/112/113/115/117/119 Revision C
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 97
Confidential
 Install the FFC according to the following procedures.
1. Lead the FFC through the hole of the Holder FFC and
Main Frame.
Figure 4-85. Installing the CR Unit (3)
2. Secure the FFC with rib A and rib B.
Figure 4-86. Installing the CR Unit (4)
Holder FFC
FFC
Hole
Rib B Rib A
3. Fold back the FFC and secure it with rib A again.
Figure 4-87. Installing the CR Unit (5)
4. Fold back only the Head FFC and secure it with rib A again.
5. Connect the FFC to the Main Board (J8, J9).
Figure 4-88. Installing the CR Unit (6)
A D J U S T M E N T
R E Q U I R E D
Whenever the CR Unit is removed/replaced, the required
adjustments must be carried out.
• Chapter 5 “ ADJUSTMENT” (p.110)
Rib A
FFC
FFC
Rib A
Head FFC