SE Group Confidential (Related Staff Only) Until: Permanent
19
1. Make sure thickness-gauge(2.0mm) can be passed and
thickness-gauge(2.5mm) can’t be passed AGAIN at 2 locations (Black and Cyan).
Adjust tank height
2.0mm => Can be Passed
2.5mm => Can’t be Passed
2. Check the vertical position
of Ink Tank
3.Check the front and
rear position of Ink Tank.
OK!!
NG!!
Set Ink Tank again
If it is not enough to hold/insert the Ink Tank,
please set this Ink Tank again.
C A U T I O N
NG!!
Set Ink Tank again
OK!!
If it is not enough to hold/insert the Ink Tank,
please set this Ink Tank again.
C A U T I O N
To Next Page
Loading...
