Epson V11H281020 - PowerLite 400W WXGA LCD Projector User Manual (English)

Other manuals for Epson V11H281020 - PowerLite 400W WXGA LCD Projector

User Manual42 pages

User Guide1 page

Update Guide4 pages

Declaration Of Conformity4 pages

Questions and Answers:

A
Ashley WileyAug 11, 2025
Why can't I monitor or control my Epson Software projector?
- J
  Jennifer CarlsonAug 11, 2025
  If Epson Software EasyMP Monitor cannot monitor or control the projector, first ensure the network cable is correctly connected; if not, reconnect it. Then, verify the settings in the Network configuration menu. Also, confirm that EasyMP Monitor is correctly installed on your computer by uninstalling and reinstalling it. Ensure all projectors are registered. Finally, the projector's Standby Mode should be set to Communication On (or Network On), or Network Monitoring should be set to On in the configuration menu to enable monitoring and control via EasyMP Monitor in standby mode.
G
Gina MartinezAug 18, 2025
What to do if Epson Software doesn't send e-mail messages when a problem occurs?
- A
  albert02Aug 18, 2025
  If you are not receiving e-mail notifications from Epson Software when a problem occurs, check that the SMTP server IP address, Port Number, and Recipient mail address are correctly configured. Also, ensure the projector's Standby Mode is set to Communication On (or Network On) or Network Monitoring is set to On in the configuration menu. If the projector has momentarily stopped working due to a critical problem, it won't be able to send e-mails; in this case, and if the projector cannot be reset after checking, contact Epson. Finally, verify that the projector is receiving power and that the circuit breaker hasn't tripped.
A
Adam JimenezAug 25, 2025
Why can't I monitor my Epson Monitor when it's in standby mode?
- S
  susan79Aug 25, 2025
  To monitor and control the Epson Monitor when it is in standby mode, the 'Network Monitoring' or 'Standby Mode' configuration menu must be set to 'ON' or 'Network ON'.
P
Perry MccannAug 29, 2025
What to do if I don't receive email notifications for my Epson Monitor?
- A
  Aaron CollinsAug 30, 2025
  If you are not receiving email notifications when a problem occurs with your Epson Monitor, ensure that the 'Network Monitoring' or 'Standby Mode' configuration menu is set to 'ON' or 'Network ON'. This setting enables the mail notification function while the projector is in standby mode.
R
Ronald MurphySep 5, 2025
Why is my Epson Monitor not sending email messages?
- C
  Courtney ChoiSep 5, 2025
  If your Epson Monitor cannot send e-mail messages, it might be due to a critical problem causing the projector to momentarily stop working. If the projector cannot be reset even after it has been checked, contact Epson.

Epson V11H281020 - PowerLite 400W WXGA LCD Projector Specifications

General

Type	LCD Projector
Native Resolution	WXGA (1280 x 800)
Speakers	10W Mono
Display Technology	LCD
Video Input	HDMI, VGA, Composite Video, S-Video
Audio Input	3.5mm mini-jack
Audio Output	3.5mm mini-jack
Connectivity	USB
Aspect Ratio	16:10 (native), 16:9, 4:3
Lamp Type	UHE
Operating Temperature	41°F - 95°F (5°C - 35°C)
Operating Humidity	20 - 80%