Epson XP-2101 User Manual (English)

To Next Page

Start Here

Load paper

See the online User’s Guide for information about loading

capacity, available paper types and sizes, and loading

envelopes.

1 Make sure the product is not charging. Then ﬂip the

feeder guard forward, raise the paper support and tilt it

backwards slightly, and slide out the output tray.

2 Slide the edge guide all the way out.

3 Load paper, glossy or printable side up and short edge

ﬁrst, against the right side of the rear paper feed slot.

4 Slide the edge guide against the paper, but not too tightly,

and ﬂip the feeder guard back.

IMPORTANT: Before using this product, make sure you read

these instructions and the safety instructions in the online

User’s Guide.

Note: This printer is designed for use with Epson

cartridges only, not

third-party cartridges or ink. For important ink information, visit

www.latin.epson.com/tintaepson or see your printer box.

Unpack

Note: Do not open ink cartridge packages until you are ready to install

the ink. Cartridges are vacuum packed to maintain reliability.

1 Remove all protective materials from the product.

2 Lift up the scanner unit until it locks into place and

remove all protective materials from inside the product.

Caution: Do not touch the ﬂat white cable.

3 Lower the scanner unit.

Turn on and configure

1 Connect the power cord to the back of the product and to

an electrical outlet.

Caution: Do not connect to your computer yet.

2 Turn on the product and wait for the ink light to turn on.

Note: If all of the printer lights are ﬂashing, an error has occurred.

Turn off the printer, lift the scanner unit and remove any protective

material that has been left inside. Then turn the printer back on.

Install ink cartridges

Caution: Keep ink cartridges out of the reach of children and do not

drink the ink.

Note: The included initial cartridges are designed for reliable printer

setup and cannot be used as replacement cartridges or resold. After

setup, the remaining ink is available for printing.

1 Lift up the scanner unit until it locks into place.

2 Gently shake the black ink cartridge.

Note: Do not shake the other ink cartridges.

3 Unpack the ink cartridges.

4 Remove only the yellow tape from each ink cartridge.

Caution: Do not remove any other labels or seals, or ink will

leak. Do not touch the green chip on the cartridge.

5 Insert the cartridge in the holder for each color. Press

each cartridge down until it clicks.

6 Lower the scanner unit.

7 Press the stop button to start charging the ink delivery

system. Ink charging takes approximately 6 minutes.

Ink charging is complete when the power light stops

ﬂashing.

Caution: Don’t turn off the printer or raise the scanner unit while

it is charging or you’ll waste ink.

XP-2101

Need help?

Do you have a question about the Epson XP-2101 and is the answer not in the manual?

Epson XP-2101 Specifications

General

Print Technology	Inkjet
Max Print Resolution	5760 x 1440 dpi
Functions	Print, Copy, Scan
Scanner Type	Flatbed
Scan Resolution	1200 x 2400 dpi
Paper Tray Capacity	100 sheets
Display	No
Weight	3.9 kg
Print Speed Black	8.0 ppm
Print Speed Color	4.0 ppm
Connectivity	USB, Wi-Fi
Paper Handling	100-sheet input tray
Supported Paper Sizes	A4, A5, A6, B5, DL
Ink Cartridge Compatibility	Epson 603
Dimensions	390 x 300 x 146 mm