9. Lower the scanner unit.
10. Press the stop button.
The print head moves to its home position and the printer starts charging the ink. This takes about 2
minutes to complete. When the power light stops flashing and remains on, ink charging is finished.
Caution: Never turn off the product while the power light is flashing or you will waste ink.
Note: If the ink light is on after the print head moves to its home position, an ink cartridge may not
be installed properly. Press the stop button, then press the ink cartridge down until it clicks into
place.
If you remove a low or expended ink cartridge, you cannot re-install and use the cartridge.
Caution: If you remove an ink cartridge for later use, protect the ink supply area from dirt and dust and
store it in the same environment as the printer. The valve in the ink supply port is designed to contain
any excess ink, but do not touch the ink supply port or surrounding area. Always store ink cartridges with
the label facing up; do not store cartridges upside-down.
141
To Next Page
Loading...
