Light status Condition/solution
Paper is jammed in the product. Remove the jammed paper, and press
The power light is flashing
the B&W copy button or the color copy button to clear the error.
The paper light is flashing
No paper is loaded or multiple sheets fed at one time. Load paper in the
The power light is flashing
product, and press the B&W copy button or the color copy
The paper light is on
button to clear the error.
Ink in a cartridge is low. You can continue printing, or check which
The power light is on or
cartridge is low and replace it.
flashing
The ink light is flashing
An ink cartridge is expended or not installed correctly. Replace or
The power light is on or
reinstall the cartridge. (Depending on the color of the expended
flashing
cartridge and how you are printing, you may be able to continue printing
The ink light is on
temporarily.)
The ink pads are near the end of their service life. Contact Epson for
The power light is on or
flashing
support. (To continue printing, press the B&W copy button or the
color copy button.)
The ink light is flashing
The paper light is flashing
An error has occurred during firmware updating. Connect your product
The ink light is on
using a USB cable and try updating the firmware again. If the error
The paper light is on
message continues, contact Epson for support.
The WiFi light is on
A printer error has occurred. Turn the product off and then back on
The power light is flashing
again. If the error continues, check for a paper jam. If the error persists,
The ink light is flashing
contact Epson for support.
The paper light is flashing
The WiFi light is flashing
The WiFi light is flashing WiFi connection error. Press the Wi-Fi button on the printer to clear the
orange error and try again.
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD screen, or lights on the control panel will advise you when these parts need replacing. If this
happens during the standard warranty of the product, the exchange of the product or replacement of the
162
To Next Page
Loading...
