Start Here
2 Pull on the front cover to pull out the lower paper
cassette.
lower
cassette
3 Slide the edge guides to the sides of the paper cassette.
4 Set the front edge guide to the paper size you are using.
Then insert paper with the glossy or printable side
facedown.
Note: Make sure the paper is loaded against the edge guide
and not sticking out from the end of the cassette.
5 Slide the edge guides against the paper, but not too
tight. Make sure the paper is under the tabs on the edge
guides.
6 Keep the cassette flat as you insert it.
7 Pull out the output tray.
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes:
Para obtener instrucciones de configuración en español, consulte la
Guía de instalación en www.epson.com/support/xp600sp (requiere
una conexión a Internet).
1
Unpack
Caution: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
1 Remove all protective materials from the printer,
including from inside the printer.
2 Lower the scanner unit.
2
Turn on and adjust
1 Connect the power
cord to the back of
the printer and to an
electrical outlet.
Caution: Do not connect
to your computer yet.
2 Press the power button, then adjust the
control panel.
3
Select settings
Press or to select your language, then press OK.
Note: You can change the language using the product’s control
panel. For more information, see the online
User’s Guide.
4
Install ink cartridges
1 Lift up the scanner unit.
2 Gently shake the BK (black) ink cartridge only. Do not
shake the PBK (photo black) cartridge or any of the other
color ink cartridges. Unpack the ink cartridges.
Caution: Do not touch the areas shown below. Doing so may
prevent normal operation and printing.
3 Remove the cap from each ink cartridge. Store the caps
in the included plastic bag.
Note: Save the caps and use them to recap the ink cartridges
after removing them for storage or disposal.
4 Insert the cartridges head first in the holder for each
color. Press each cartridge down until it clicks.
5 Lower the scanner unit.
6 The printer starts priming the ink. This takes about 6
minutes. When you see a completion message on the
printer’s LCD screen, priming is complete.
Note: The cartridges included with the printer are designed
for printer set up and not for resale. After some ink is used for
priming, the rest is available for printing only in the same printer.
Caution: Don’t turn off the printer or raise the scanner unit
while the printer is priming or you’ll waste ink.
5
Load paper
The printer has 2 paper cassettes. You can load the following
paper sizes:
• Upper cassette (Cassette 1): 4 × 6- or 5 × 7-inch photo
paper
• Lower cassette (Cassette 2): letter-size, A4, legal-size, or
8 × 10-inch paper. (See the instructions below for loading
paper in the lower cassette.)
See the
Quick Guide for instructions on loading paper in the
upper cassette. See the online User’s Guide for available
paper types, sizes, loading capacity, and instructions for
loading legal-size paper or envelopes.
1 Lower the front cover (if it’s not open already).
XP-600 Small-in-One
TM
Printer
To Next Page
General
