Why is my EQUAL-I-ZER Automobile Accessories tow vehicle too high in front?
If your tow vehicle sits too high in the front when using EQUAL-I-ZER Automobile Accessories, it's likely due to insufficient weight distribution. To fix this, add spacer washers or raise the L-bracket, following the under-adjustment guidelines.
What to do if front end feels “floaty” with EQUAL-I-ZER Automobile Accessories?
If the front end feels "floaty" while using EQUAL-I-ZER Automobile Accessories, it indicates that not enough weight is being distributed. You should add spacer washers or raise the L-bracket by following the under-adjustment guidelines.
Why EQUAL-I-ZER Automobile Accessories creaking and groaning?
Creaking and groaning noises in your EQUAL-I-ZER Automobile Accessories can be due to: * Dirty or dry friction surfaces in the hitch head: Clean and lubricate the friction surfaces of the head and sockets using Equal-i-zer High Performance Lubricant. * Normal Function: Some noise is expected with the use of an Equal-i-zer Integrated Sway Control hitch, indicating effective sway-dampening friction.
What to do if EQUAL-I-ZER Automobile Accessories trailer is too low or too high?
If your EQUAL-I-ZER Automobile Accessories trailer sits more than 1-1/2” from level, it could be due to: * Incorrect shank causing improper hitch ball height: Consult your local Equal-i-zer hitch dealer about using a specialty length shank. * Improper hitch ball height with correct shank: Follow the Trailer Pitch Adjustment section to change the ball height.
What causes bent or broken L-bracket, L-pin, or link plate in EQUAL-I-ZER Automobile Accessories?
Bent or broken L-brackets, L-pins, or Link Plates on your EQUAL-I-ZER Automobile Accessories can be caused by: * Link Plates installed too far back from the hitch ball center: Follow instructions and set the center of the Link Plates between 25”- 32” from the center of the coupler. * Link Plates not installed “upside down” for bottom-mount coupler: Follow the instructions to install Link Plates correctly.
How to fix “walking” sway bracket assembly on EQUAL-I-ZER Automobile Accessories?
If the Sway Bracket Assembly is “walking” on your EQUAL-I-ZER Automobile Accessories, it is probably because the Link Plates are not tight enough. Follow the instructions to tighten the Link Plates correctly.
Why does my EQUAL-I-ZER Automobile Accessories trailer sway?
Trailer sway with EQUAL-I-ZER Automobile Accessories can occur due to several reasons: * Not enough weight distribution: Address this by adding spacer washers or raising the L-bracket, following the under-adjustment guidelines. * Light tongue weight: Ensure the tongue weight is at least 10% of the Gross Trailer Weight. Reposition the load in the trailer as needed and remove any cargo carriers from the rear of the trailer. * Improperly rated or underinflated tires: Check and inflate or replace tires as necessary. * Loose socket bolts: Tighten the socket bolts to between 60 and 100 ft-lbs torque. * Tow capacity exceeded: Verify your tow vehicle is rated for the trailer’s Tongue Weight and Gross Vehicle Weight. If not, do not tow. * Hitch Undersized: Ensure your Gross Trailer Wei...
Determine sway bracket placement on trailer frame, typically at 32 inches.
Assemble link plates to trailer frame, considering coupler style for correct fit.
Measure front axle height uncoupled, coupled without WD, and coupled with WD.
Use snap-up lever to lift spring arms onto L-brackets and secure with pins.
Adjust by adding/removing spacer washers or altering L-bracket height for balance.
General| Brand | EQUAL‑I‑ZER |
|---|---|
| Model | 90-00-0400 |
| Category | Automobile Accessories |
| Language | English |
To Next Page