How to fix a EQUATION Heater remote control that is not working?
If the remote control for your EQUATION Heater isn't working, there are a few potential causes: * You might be too far from the stove; try moving closer. * The battery may be dead; try replacing it.
What to do if the EQUATION Heater display is off and the buttons don't work?
If the display is off and the buttons aren't working on your EQUATION Heater, it could be due to several reasons: * There may be a problem with the power supply. Ensure the device is properly connected to a power source. * The rear switch might be off. Place the switch in the "1" position. * The control box might be defective. Try disconnecting the stove for a minute, reconnecting it, and turning it on again.
Why EQUATION Heater does not start automatically?
If your EQUATION Heater doesn't start automatically, consider these possible causes: * The pellet tank might be empty. Refill the tank with pellets. * The pellet may not be descending into the brazier. After disconnecting the socket, check that the pellet is not stuck in the chute and that the endless screw is not stuck by a foreign body. * The brazier may be poorly positioned or dirty. Clean the brazier and ensure the spark plug is positioned in front of it. * The smoke evacuation circuit might be obstructed. Remove any foreign objects from the chimney or smoke duct. * The pellets might be too wet. Replace the pellets and check the storage location.
What to do if my EQUATION Heater has an ignition defect?
If your EQUATION Heater has an ignition defect, it might be due to excessive ash accumulation in the brazier. Try cleaning the brazier. Also, the ignition procedure may be incorrect; try repeating it.
Why is my EQUATION Heater always working at maximum power?
If your EQUATION Heater always works at maximum power, it could be because the room thermostat is in the maximum position. Try setting the thermostat temperature again.
Why does the smoke extraction fan in my EQUATION Heater work continuously?
The smoke extraction fan in your EQUATION Heater might be working continuously because the stove is still being cooled. Wait for the cooling process to finish.
Instructions for the routine cleaning of the stove components and ash removal.
General| Heating power | 2000 W |
|---|---|
| Thermostat | Yes |
| Overheat protection | Yes |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Safety Features | Overheat protection |
To Next Page
