Need help?Do you have a question about the Equipter RB 4000 and is the answer not in the manual?
General| Brand | Equipter |
|---|---|
| Model | RB 4000 |
| Category | Excavators |
| Language | English |
Use only manufacturer-recommended replacement parts for fit and quality.
Always take proper safety precautions while servicing this equipment. Refer to Operator's Manual.
Steps to remove and replace the air filter on the RB4000.
Instructions for safely removing and installing the spark plug on the RB4000.
Procedure for draining and refilling the engine oil for the RB4000.
Steps to unscrew the old and twist on the new hydraulic oil filter.
Visually inspect brake pads for wear and check fuse and brake fluid if not working.
Visually inspect the parking brake handle for wear and tighten if loose.
Test the breakaway system by pulling the pin and listening for actuator noise; check fuse if needed.
Visually inspect hydraulic hoses for dry rot, wear, or exposed wires; replace if damaged.
Inspect front and rear tires, check pressure, and torque lug nuts to 140 ft-lbs.
General guidance on lubricating various fittings on the RB4000.
Grease the 3"x5" and 4"x6" tubes on the slide rails with provided gloves.
Grease the zerk and pin for the wheel lock on units manufactured before October 2019.
Disengage, grease the wheel lock pin, and replace the wheel lock pin.
Remove grease cap, grease zerk, spin tire, and replace cap on front axle hubs.
Lubricate the drive system fitting every 40 hours by accessing the grease zerk.
To Next Page