Document Revision: ERAVAP_a-8018 3
1.1 Safety and Warning
This instruction manual does not claim to address all of the safety issues
associated with the use of the instrument and samples. It is the responsibility
of the user to establish health and safety practices and determine the
applicability of regulatory limitations prior to use.
Make sure you read and understand all instructions and safety precautions listed in this
instruction manual before installing or operating the equipment to ensure smooth operation
and avoid damage to the equipment or its accessories. If a malfunction occurs, consult chapter
Errors and Warnings If a problem persists or if there are any questions concerning the
operation of the equipment or about the information in this manual, please contact your local
eralytics distributor or eralytics.
Performance of installation, operation, or maintenance other than those described in this
manual may result in a hazardous situation and may void the manufacturer’s warranty.
Never operate equipment that is not correctly installed. Ensure that all operators are fully
trained to use the analyzer correctly and safely. Unqualified personnel must not operate the
equipment. Avoid causing damage to the equipment or its accessories through incorrect
operation.
Always consult the material safety datasheet for any sample, chemical used for measurement,
cleaning and maintenance and ensure that proper safety equipment is available and used by
the operator.
Follow the precautions below for the handling and measurement of flammable
samples and cleaning agents:
• Observe all safety regulations regarding the handling of the samples to be
measured, rinsing agents and waste liquids (e.g. use of safety glasses, gloves,
respiratory protection...).
• Do not store inflammable material near the instrument.
• Do not leave sample/solvent containers uncovered.
• Clean all spillages immediately.
• Prior to starting a measurement, make sure that the filling and waste hoses and
the cell connection tube are properly connected.
• Ensure that the ERAVAP is located in a sufficiently ventilated area, free from
inflammable gases and vapors.
• Keep a fire extinguisher at hand.
• Keep any sources of ignition, like sparks and unshielded flames, at a safe
distance from the instrument.
To Next Page
Loading...