15
14
ASSEMBLY
01
UNPACKING
• Unpack all parts and lay them on a at, stable surface.
• Remove all packing materials and shipping devices, if applicable.
• Make sure the delivery contents are complete and free of any damage. If you nd that parts
are missing or show damage do not use the product but contact your dealer. Using an
incomplete or damaged product represents a hazard to people and property.
• Ensure that you have all the accessories and tools needed for assembly and operation.
This also includes suitable personal protective equipment
WARNING!
The product and the packaging are not children’s toys!
Children must not play with plastic bags, sheets and small parts! There is a
danger of choking and suffocation!
02
ASSEMBLY
BLADE COVER (FIG. A)
Remove the blade cover(12) from the cutting device.
CHARGING YOUR BATTERY PACK
The battery has been shipped in a low charge condition. Charge it fully before rst use.
Refer to the charger instruction manual for the details.
TO REMOVE OR INSTALL THE BATTERY PACK (FIG. B1, B2)
Depress the battery pack release button (7) to release and slide the battery pack out
from your tool.
After recharge, slide it back into your tool. A simple push and slight pressure will be
sufcient.
BATTERY PACK POWER BAR
The Li-Ion battery pack (9) is equipped with a POWER BAR (8) which is used to give an
indication of the battery pack’s remaining charge. Press the POWER BAR button (8) to
check battery charge as below. The LED will stay lit for approximately 5 seconds.
8
76-100% Charge
51-75% Charge
26-50% Charge
5-25% Charge
under 5% Charge
Flash On Off
To Next Page
Loading...
