26
NOTE: Perform a trial cut in a piece of test wood.
Operation
01
General routing (Fig. H)
WARNING! During operation ne dust will be generated!
These dusts are highly inammable and explosive! Do not smoke during
operation, keep heat sources and open ames out of the working area!
Always wear a dust mask to protect yourself against hazards resulting
from ne dust!
NOTE: Before rst use on a workpiece make yourself familiar with the
different routing functions using waste material.
Even if you are familiar with this product, always make a trial cut on waste
material to test the adjusted speed, routing depth and chosen router bit.
1. Ensure the workpiece is free of obstacles like nails or screws before operation.
Remove them if required.
2. Always attach the desired router bit.
3. Hold the product rmly with a hand on its body before switching it on.
4. Always wait until the router bit has reached its full speed before cutting.
5. Move the product forward/ backward with a slow even speed. Pay attention to the
direction of feed.
6. Bring the product to a stop at the end of the cut, release the on/off switch and wait
until the router bit has come to a complete stop before removing the product from
the workpiece.
WARNING! Danger of kickback! Apply the product to the workpiece only
when switched on!
WARNING! Always ensure the base plate lays at on the workpiece
during operation! Do not try to make cuts with the product only held by
one hand!
710W router MNL_EPR710_TPS_GB_V1_V10518_20180606.indd 26 6/6/18 8:40 AM
To Next Page
Loading...