Erbauer ERB110SSW - Troubleshooting Common Issues

PROBLEM CAUSE SOLUTION
Motor will not run. 1. Problem with power
cord or outlet.
2. Motor defective.
-Check the plug fuse.
Check power at mains supply
socket.
-Do not attempt any repair.
-Have it repaired by a quali
-
fied service technician.
Blades breaking. 1.Tension too high.
2.Feeding too quickly.
3.Wrong blade.
4.Blade twisting in wood.
-Adjust tension.
-Reduce feed rate.
-Use narrow blades for cutting
thin wood, tight corners and
and curves. Use wide blades
for thicker wood and large
curves.
-Reduce side pressure on
blade, check blade tension.
Vibration (there is al
-
ways a certain amount
of vibration when the
saw is running)
1. Improper mounting of
saw.
2. Improper bracing.
3. Loose table or table
resting against motor.
4. Loose motor mounting.
-Check mounting.
-Check saw mounting instruc
-
tions.
-Tighten table lock knob.
-Tighten motor mounting
screws.
Blade runout (blade not
properly aligned with
arm motion).
1. Blade holders out of
line.
-Realign blade holders and
blade.