Erbauer ERN642ATL-I - User Manual

68 pages

Save Page as PDF

To Next Page

AIR BODY SAW

ERN642ATL-I

Year

Guarantee

BX220IM

Questions and Answers

D
debracruzNov 3, 2025
What to do if my Erbauer Saw runs slowly?
- G
  Gloria HernandezNov 3, 2025
  If your Erbauer Saw is running slowly, several factors could be the cause. First, check for grit or gum inside the tool and flush it with air-tool oil or gum solvent. Ensure the tool is properly lubricated according to the manual's instructions. Verify that the air pressure is adequate by adjusting the regulator on the tool to the maximum setting and the compressor regulator to a maximum of 90 PSI/6.3 BAR. Inspect the air hose for leaks and tighten or seal any found using sealing tape. Also, ensure the air hose is the correct size, especially for long hoses or tools requiring high air volumes, which may need a 1/2 inch I.D. or larger hose. Avoid connecting multiple hoses with quick-connect fittings, as this can cause pressure drops; connect hoses directly. Finally, consider that a worn rot...
E
Erica HallNov 16, 2025
Why is my Erbauer Saw not operating?
- A
  Amber HaydenNov 16, 2025
  If your Erbauer Saw isn't operating, there could be several reasons. Check for grit or gum within the tool and flush it out using air-tool oil or a gum solvent. Make sure the tool is properly lubricated as per the manual's lubrication guidelines. Ensure sufficient air pressure by adjusting the tool's regulator to its maximum setting and setting the compressor regulator to a maximum of 90 PSI/6.3 BAR. Inspect the air hose for any leaks, and if found, tighten and seal the hose fittings using sealing tape. Confirm that the hose is the correct size, especially if it's a long hose or the tool requires a large air volume; in such cases, a hose with an I.D. of 1/2 inch or larger may be necessary. Avoid using multiple hoses connected with quick-connect fittings, as this can lead to pressure drops;...