ADDITIONAL SAFETY POINTS FOR YOUR ROTARY SANDER
1. Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
2. Fully unwind cable drum extensions to avoid potential
overheating.
3. When an extension cable is required you must ensure it has
the correct ampere rating for your power tool and is in a safe
electrical condition.
4. Ensure your mains supply voltage is same as indicated on the
rating plate.
5. Your tool is double insulated for additional protection against a
possible electrical insulation failure within the tool.
6. Always check walls, oors and ceilings to avoid hidden power
cables and pipes.
7. After long working periods external metal parts and accessories
could be hot.
8. If possible, ensure the workpiece is rmly clamped to prevent
movement.
9. Your rotary sander is a hand held tool, do not clamp your rotary
sander.
10. Before sanding, check the area is free of nails, screws, etc.
11. Never stop the rotary sander by applying a force to the
baseplate.
12. Only use paper in good condition. Do not use torn or worn
paper.
13. Do not sand material containing asbestos due to a health risk.
14. Do not sand lead based paint due to the risk of lead poisoning.
15. Do not eat or drink in the working area of the sander.
16. Do not allow people to enter the working area without wearing a
dust mask.
17. Where possible, seal off the working area to contain the dust for
later removal.
18. Your tool is designed for dry sanding only, not wet sanding.
19. Your tool is designed for general purpose light polishing of wood
and metals.
20. Do not sand magnesium material due to the risk of re.
21. Always wear safety glasses or eye shields when using the
sander. Everyday eyeglasses have only impact-resistant
To Next Page
Loading...
