Ergo 8 - Technical Specifications

User’s Manual
8
3. TECHNICAL SPECIFICATIONS
Model:
ERGO 8 ERGO 11
Resin Volume: 7.4 litres 10.5 litros
Tank: 203x330 203x432
Working flow: 1.8m³/h 2.1m³/h
Maximum flow: 2.1m³/h 2.1m³/h
Exchange capacity: 17.6ºHFxm³ 23.7ºHFxm³
Salt/regeneration: 0.36 Kg Salt 0.36 Kg Salt
Salt/resin litre: 49.3 g/L 33.7 g/L
Maximum hardness: 60 ºHF 73 ºHF
Rinse flow: 3.78 LPM 3.78 LPM
Water comsumption/reg: 25
Regeneration time: 15 min
Max. iron (ferrous): <0.5 mg/L
Max. iron (ferric): <0.01 mg/L
Max. free chlorine: ≤1 mg/L
pH range: 5-10
Room temperature: Protection against freezing
Temperature range: 1.7-35°C
Pressure range: 2.5 - 5.5 bar
Min. flow rate: 0.17m
3
/h
Pressure rating: 8.6 bar
Electrical connection: NA
Rated eletrical power: NA
Protection class: NA
Dimensions (h x d x w): 506 x 293 x 498 608 x 298 x 501
Setting of the hardness regulator
ERGO 8 ERGO 11
Letter
Hardness
Letter
Hardness
ppm ˚dH ˚TH ppm ˚dH ˚TH
A 112 6 11 A 79 4 8
B 124 7 12 B 88 5 9
C 138 8 14 C 98 6 10
D 157 9 16 D 111 6 11
E 180 10 18 E 128 7 13
F 213 12 21 F 152 9 15
---- 235 13 23 ---- 167 9 17
G 262 15 26 G 185 10 19
---- 293 16 29 ---- 209 12 21
H 336 19 34 H 238 13 24
- 352 20 35 ---- 278 16 28
---- 390 22 39 I 334 19 33
- 441 25 44 - 358 20 36
I 470 26 47 ---- 417 23 42
- 502 28 50 - 501 28 50
---- 561 31 56 J 549 31 55
- 600 34 60 - 602 34 60
LIMIT 730 41 73
IMPORTANT: Please note that not all settings shown on the disc may be found in
the chart. Those settings not found in the chart are NOT APPLICABLE.
---- Represents the setting in between two letters
- Represents the setting either 1/4 after or 1/4 before a letter.