Operating instruction
Hydraulic lifting system with Hand crank
Documant no.: B-00011
Edition 2022 08
Operating instruction EN
Copyright by Ergoswiss AG
Page 1 of 13
Operating instruction – Hydraulic system with Hand crank
It is essential to read this operating instruction thoroughly before commissioning the system.
This operating instruction has to be stored in the immediate vicinity of the system.
Hand crank
Pump
Hydraulic tubing
Lifting element (Cylinder, Linear unit, Table leg)
Errors and technical changes reserved.
Ergoswiss AG does not assume any liability for operating errors or
using the products outside of the intended purpose use.
At the time of delivery Ergoswiss AG will replace or repair defect
products within accordance with the warranty provisions. In addi-
tion, Ergoswiss assumes no other liability.
For your questions and special custom demand Ergoswiss AG will
be at your disposal.
Ergoswiss AG
Nöllenstrasse 15
CH-9443 Widnau
Tel.: +41 (0) 71 727 06 70
Fax: +41 (0) 71 727 06 79
info@ergoswiss.com
www.ergoswiss.com
To Next Page
Need help?
General