Ergotron Dual Monitor and Handle Kit - Mounting Solution Attachment; Option A: 100 x 100 mm Hole Pattern; Option B: 50 x 50 mm Hole Pattern; Install Portrait;Landscape Stop Screw

888-97-314-G-03 rev. F • 03/17
2 of 6
1
50 mm
100 mm
50 mm
100 mm
1
2
A B
4x
M6 x 8mm
4x
M6 x 8mm
M4 x 7mm
4x
0°
M3.5 x 6mm
M3 x 6mm
1x
4 mm
4 mm
EN
There are 2 ways to mount this product. Based on what mounting solution you
are attaching this product to, follow the appropriate mounting instructions.
Install the portrait/landscape stop screw in your mounting solution
to eliminate the P/L rotation feature.
Make sure the 'Notch' is positioned at the top of the Bow.
If your mounting solution is straight up and down vertical,
make sure the 'Notch' is positioned at the top of the Bow.
If your mounting solution slants back a little, make sure the
'Notch' is positioned at the bottom of the Bow.
Top view of attachment.
A. Attaching this product to a mounting solution with 100 x 100 mm mounting hole pattern.
B. Attaching this product to a mounting solution with a 50 x 50 mm mounting hole pattern.
Top view of attachment.