888-45-175-W-01 rev.F • 12/14
10 / 12
5
4mm
4mm
a
b
4mm
4mm
ENGLISH
CAUTION: DO NOT overtighten fasteners.
Overtightening may cause damage to your
equipment.
Lift – Up and down
Tilt – Forward and Backward
CAUTION: DO NOT remove screw. Removing
screw may cause damage to equipment.
Increase Friction
If this product moves too easily, then
you'll need to increase friction:
Decrease Friction
If this product is too diffi cult to move,
then you'll need to decrease friction:
Important! You will need to adjust this product after installation is complete. Make sure all your equipment is
properly installed on the product before attempting adjustments. This product should move smoothly and easily
through the full range of motion and stay where you set it. If movements are too easy or diffi cult or if product
does not stay in desired positions, follow the adjustment instructions to create smooth and easy movements.
Depending on your product and the adjustment, it may take many turns to notice a difference. Any time equipment
is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat
these adjustment steps to ensure safe and optimum operation.
Increase Lift Strength
If the mounted weight is too heavy or
this product does not stay up when
raised, then you'll need to increase
Lift Strength:
Decrease Lift Strength
If the mounted weight is too light or
this product does not stay down when
lowered, then you'll need to decrease
Lift Strength:
To Next Page
Loading...
