Item No. 07464
English/French/Spanish Page 2 of 4
SPECIFICATIONS
Rated Capacity
800 lbs. distributed load and
1600 lbs when using 2 ramps
Ramp dimensions
(Unfolded)
80” long x 11” wide
Ramp dimensions
(Folded)
40” x 11” x 4
1/8
”
USAGE
Step 1
Be sure you are loading on a hard, level and stable surface and that the vehicle you
are loading onto is in “Park” with the emergency/parking brake on and the engine “off”.
Unfold and place the lip edge of the ramp against the tailgate of the vehicle. The tailgate
should not be more than 30” in height or the ramp incline will be to steep.
Step 2
Secure the ramp to the vehicle using the adjustable strap. After the strap is secure, test
the ramp by pulling backwards on it. Make sure it does not slide back or disengage from
the loading surface.
Step 3
Once the ramp is secure and the area is safe to proceed with loading, move the vehicle
to be loaded between the ramps and center the load between both ramp rails.
Step 4
Proceed with loading the vehicle, making sure that the ramp is sustaining the load and
not bowing from the weight.
Step 5
Continue until the vehicle is fully loaded. Secure the brake and tie down as needed.
Step 6
Unhook the adjustable strap, fold the ramp and lock into the folded position. Store in a
clean, dry and safe place where damage will not occur.
To Next Page
Loading...