15 / 20
To stop cleaning the floor:
1. Press the Water Pump button to stop the water releasing;
2. Press the Brush button to stop the brush. After pressing the Brush button,
continue moving forward with the E100 for approximately 15-30 feet.
3. Press the Vacuum button to stop the vacuum.
4. Press the On/Off button to power off the E100.
Note:
Pressing the main On/Off switch will immediately stop the E100. For best results, we
recommend first turning off the Water Pump button and continuing moving the E100
forward for approximately 15-30 feet to ensure any remaining dust or water is removed
from the floor.
Warning!
Ø Do not operate the E100 at greater than an arm's length. Operating below a 45-
degree angle can cause water to run into the vacuum engine.
Ø Dispose of water or cleaning solution from both tanks in an appropriate drain.
USER MANUAL
To Next Page
Loading...