18 / 20
3. Once the plastic part is removed, you can easily take off the rear rubber blade.
4. Push the eight screws through the front blade to remove the squeegee front plate.
5. Take off the rear rubber blade.
6. Inspect the front and rear rubber blades:
a. The first time: Flip the blades so the top of the blade is facing the floor.
Push the front plate screws through the holes.
b. The second time: Attach a new set of blades. Push the front plate screws
through the holes.
7. Put back the plastic rear plate.
8. Screw the eight plastic nuts on the back.
Caution: The special squeegee blades contain small arrow-like shapes cannot be
switched. These need to be replaced every time.
Attach the Squeegee
1. Take the vacuum hose.
2. Insert the hose connector (see image to right) in the
squeegee.
3. Twist the hose connector one quarter turn for a firm
fit.
4. Carefully pull the vacuum hose from the top of the
machine.
5. Hold the scrub deck firmly with one hand.
6. Align the pins on the scrub deck with the holes on the
squeegee.
7. Screw the squeegee in place.
USER MANUAL
To Next Page
Loading...