ERICO Eritech Cadweld

To Next Page

To Previous Page

The CADWELD

ONE SHOT Process

Fig. 4

The conductors should be clean and dry before the

connection is made. Use a propane torch to dry wire

conductors and remove remaining cleaning residue,

solvent, or water before making the CADWELD

ONE SHOT connection.

Fig. 5

Next, use a wire brush to further prepare the surface

of the conductors and ground rod (CADWELD

T-313

or T-314 brush).

Scrape the outer surface to remove dirt and oxidation.

You will notice a slight color change.

Fig. 6

Each CADWELD ONE SHOT contains a rubber

grommet at the bottom of the mold.

Gently turn the CADWELD ONE SHOT onto the

ground rod until the ground rod reaches the stopper

and cannot go any further.

ERICO Eritech Cadweld - Page 31