The CADWELD
®
PLUS ONE SHOT Process
Fig. 4
The conductors should be clean and dry before the
connection is made. Use a propane torch to dry wire
conductors and remove remaining cleaning residue,
solvent, or water before making the CADWELD
®
connection.
Fig. 5
Next, use a wire brush to further prepare the surface
of the conductors and ground rod (CADWELD T-313
or T-314 brush).
Scrape the outer surface to remove dirt and
oxidation. You will notice a slight color change.
Fig. 6
Each CADWELD PLUS ONE SHOT contains a copper
wire at the bottom of the mold.
Place the mold onto the ground rod until the ground
rod reaches the wire stopper and cannot go any
further.
34
To Next Page
Loading...