Fig. 1
Always wear protective safety glasses and gloves
while working with CADWELD
®
exothermic welding
products.
Fig. 2
Gather the proper materials and equipment for
the type of connection you are making. The typical
CADWELD system requires a graphite mold, handle
clamp, welding material, natural bristle brush for
mold cleaning, wire brush for cleaning/preparing
conductors, flint igniter, and propane torch.
NOTE: Additional materials may be required
for your specific application. Refer to your
mold instructions. Advise nearby personnel of
welding operations in the area prior to ignition.
Fig. 3
Check to ensure the graphite mold is not worn or
broken, which could cause leakage of molten weld
metal during the reaction.
The CADWELD
®
Process
2
To Next Page
Loading...