Ericsson 2219 - Power Up Radio; Check Radio After Power Up


77..22 PPoowweer r UUp p RRaaddiioo
The radio must be powered up within 48 hours after installation, even if it isThe radio must be powered up within 48 hours after installation, even if it is
not taken into service. The reason is to protect the internal units from localnot taken into service. The reason is to protect the internal units from local
climate conditions.climate conditions.
Do!Do!
Products not connected to ground risk damage from overvoltage or overcurrent.Products not connected to ground risk damage from overvoltage or overcurrent.
Always grouAlways ground prodund products according to cts according to instructions.instructions.
StepsSteps
To power up the radio:To power up the radio:
1.1.
Ge7355E
Ge7355E
Make sure that the radio isMake sure that the radio is
grounded according togrounded according to
instructions.instructions.
2.2.
Ge6816B
Ge6816B
OONN
OO
FF
FF
Switch on the external power toSwitch on the external power to
the radio.the radio.
77..33 CChheecck k RRaaddiio o AAfftteer r PPoowweer r UUpp
Once the power has been switched on, the radio is loaded with the specificOnce the power has been switched on, the radio is loaded with the specific
software. Optical indicators show the status of software. Optical indicators show the status of the radio.the radio.
Verify Radio Installation on Site
Verify Radio Installation on Site
67/67/15153131-L-LZA ZA 70701 61 600001/1/1 1 UeUen n JJ || 20201717-0-06-6-0606
3131