IndexIndex
vlan <vlan> - Insert the number of the Switching Domain. Range 1 to
200.
ethernet_port <port> - Insert the number of the Ethernet port.
Range 1 to 26.
<flows> – A single value, range or list of flow numbers. Range 1 to 8.
flow_identifying_values <flow_identifying_values> –
DEPRECATED.
Identifies the QoS the flow is associated with. There is a unique
value valid, 1; values 2 to 8 are admitted but have no
action. This parameter can be omitted.
reliability <reliability> – Decides the cell-limit and the
threshold group limit for the port. Values: highest, high, medium,
low and lowest.
priority <priority> – Decides the flow priority. Values: highest,
high, medium and low. The priority selects the queue that the packet
is placed in at the egress port.
marking <marking> - Specify the p-bits to overwrite the p-bits in the
outer VLAN. Values are none or a range 0 to 7. To use the original p-
bit from the received packet, none must be selected AND the connection
p_tag and second_p_tag must be configured as transparent.
Default Settings
flow_identifying_values: 1
reliability: medium
priority: medium
marking: none
Command Usage
Quality of service parameters are defined for each ingress flow. The connect
vlan command (see section 13.8.6 on page 114) is used to select this
command, which is used when flow selector is none..
Example:
efn# set connection_flow vlan 20 ethernet_port 1, 25 ingress flow 1 priority
low reliability lowest marking 7
To Next Page
Loading...