IndexIndex
13.8.13 set cpu restart_dhcp
Use this command to force the cpu to restart the DHCP IP address request.
The command get cpu restart_dhcp is used to get the current status of
DHCP restart. In order for this command to work, the method (get cpu method)
should be dhcp. If the method is static and the restart_dhcp command is
executed then error will be thrown.
Syntax
set cpu restart_dhcp < param>
Arguments:
<param> - Values allowed are failed, start and success.
success – to indicate DHCP restart success.
start – to restart DHCP.
failed – to indicate DHCP restart failure.
Only a value of 1”start” can be used for the set cpu restart_dhcp
command. On setting it to 1”start” DHCP procedure on EFN shall be
restarted. The get command will display the current status of DHCP
restart.
Note: When the EFN is in IPSec mode, the communication between the
ECN and the embedded nodes is protected by IPSec and the local
serial management interfaces disabled.
Example:
efn# set cpu restart -dhcp start
Note: Since the IPSec mode is forced by the DHCP message, it is possible
to check whether the node is working in IPSec mode by asserting the
get cpu command.
To Next Page
Loading...