IndexIndex
Default Setting
None.
Command Usage
The command is used to remove a configuration file used at reboot. By
removing the file, the factory default values are restored. If no configuration file
is designated as permanent, then the default values defined in the SW release
are used.
The command list is used to see all the configuration files, see section
13.9.4 on page 151. The command get configuration permanent will
display the boot file, see section 13.11.1 on page 161.
Example:
efn# config remove_permanent
13.9.9 restore
Use this command to restore configuration parameters according to a saved
configuration file.
Syntax
config restore {cancel|<File name>} [after <Time>]
Arguments:
cancel – Cancel a scheduled restore operation.
File name – The name of the configuration file. Note that the
configuration file that PEM has configured is named primary.
Time – The restore operation is delayed by specified number of minutes.
Default Setting
None.
To Next Page
Loading...