Glossary
13.9.7 remove
Use this command to remove a saved configuration file.
Syntax
config remove <File name>
Arguments:
File name – The name of the configuration file. Note that the
configuration file that PEM has configured is named primary.
Default Setting
None.
Command Usage
The command is used to remove a configuration file that has been saved. The
file appointed as permanent cannot be removed using this command. To
remove this file use the command remove_permanent, see section 13.9.8
on page 153 . All configuration files can be displayed using the command
list, see section 13.9.4 on page 151.
Example:
efn# config remove test
13.9.8 remove_permanent
Use this command to remove the permanent configuration file used at reboot.
Syntax
config remove_permanent
Arguments:
-
To Next Page
Loading...