IndexIndex
13.10 Debugging Commands
The commands listed in Table 15 on page 158 are used when debugging the
system. The error_logger is automatically enabled and its contents can be
viewed using the get command described in section 13.11 on page 161.
The set log command is used together with the debugging commands.
Table 15 Debugging Commands
Command Description Page
packet_logger
Configure, start, stop and reset the packet_logger. 158
trace_logger
Start, stop and reset the trace_logger. 160
13.10.1 set log packet_logger
Use this command to specify the ports, switching domains and protocols for
packet logging.
reset log packet_logger disables all logging by setting all the packet
logger parameters to default values. It also deletes all entries in the packet log.
Syntax
set log packet_logger
[ports ethernet_port <ports>]
[vlans vlan <vlans>]
[protocols protocol {arp|igmp|dhcp|rstp_or_stp|all}]
[enabled {yes|no}]
[capture {start|stop}]
Arguments:
ports ethernet_port <ports> – Specify the port, or range of
ports. Range 1 to 26. If enabled yes is selected, the specified ports are
added to list of the ports for logging, for the specified switching domain(s)
and protocol(s). If enabled no is selected, the specified ports are
removed from the list of the ports for logging, for the specified switching
domain(s) and protocol(s).
vlans vlan <vlans> – Specify the switching domain, or range of
switching domains. Range 1 to 200. If enabled yes is selected, the
specified switching domains are added to list of the switching domains for
To Next Page
Loading...