Glossary
Example:
efn# set log trace_logger enabled yes
13.11 Display Commmands
The get commands listed in section 13.11.1 on page 161 display information
about the configuration and the system. Type get in front of the commands
listed in the table, for example, get bandwidth_limitation
13.11.1 get
To read information about the displayed parameters and values, refer to the
command where the parameters are configured (click the page number in the
right column). If there can be multiple configurations or statuses for a specific
parameter (for example, the status of a port) and multiple ports are shown, the
parameters value is empty.
Note: Displayed parameters that are not explained where they are
configured, are explained in the table below.
Table 16 Configuration commands
Command Description Page
bandwidth_limi-
tation
Display bandwidth limitation in connections. 118
Cli
Display parameters for autologout, heartbeat and the prompt. 148
Configuration configurations - List the configuration files.
latest_restored – Display the latest restored configuration file.
permanent – Display the configuration file loaded at reboot.
-
Connection
Display the configuration of a Switching Domain at an IP-port.
dynamic_ip_addresses – The IP addresses that have been
allocated automatically and that are used for IP validation during
forced forwarding. These addresses are set independently by the
system.
virtual_mac_addresses – Virtual MAC addresses as used
during forced forwarding. These addresses are set
independently by the system.
Multicast - Display information about multicast.
107,
120
To Next Page
Loading...