Connections 13
Connect a telephone to the FCT
Connect a fixed telephone to the FCT telephone line.
Note: you will use this telephone to dial the PIN.
Switch on the FCT
Connect the power supply. The FCT switches on
automatically and the green and red light indicators
start flashing.
Enter PIN
Most SIM cards are protected with a PIN (Personal
Identity Number), which you get from your network
operator and which you need in order to access the
network.
If the SIM card is not protected by a PIN code, then
you do not need to enter the PIN. The FCT starts the
network search automatically.
If the SIM card is protected by the PIN code, then the
green and red lights will flash simultaneously.
Note: if you have the DA20 display adapter
accessory (See “Accessories” on page 38), an
“ENTER PIN” message will show on your display.
Please follow these steps to enter the PIN:
• Pick up the telephone and dial the PIN code. Press
the # key on your telephone or wait until you hear a
beep tone.
• If you make a mistake while entering your PIN,
hang up the telephone immediately and try again.
If the PIN is correct, you will hear a beep over the
telephone (positive indication tone). If it is incorrect,
a deep tone will sound (error indication tone).
If the PIN is entered incorrectly three times, the SIM
card will be blocked. If this happens, you can
unblock it by using the PUK (Personal Unblocking
Key), which you also get from your network operator.
See SIM Card Security on page 30.
To Next Page
Loading...