LBI-3890
5
To Reassemble The Radio After Service
Essentially follow the reverse of the above
instructions. However, in order to preserve moisture seals,
be sure to follow the EXACT torque and sequencing
specifications for screw engagement during reassembly.
These specifications are given in maintenance manual LBI-
38909.
For re-assembly of the Control Units (Front and
Remote Mounting) Revision "A" or later, be
sure the black "O-Ring" is lubricated properly
with "HIVAC-G" silicone grease (See Figures 1A
and 1B for instructions).
NOTE
Steps:
1. Remove dust and dirt from the black O-Ring gasket.
2. Apply proper amount of the silicone grease to a cloth as
shown in Figures 1A and 1B.
3. Put the silicon grease on the black O-Ring gasket,
covering the surface of the gasket evenly (see Figure
1A and 1 B).
No Fibers of the cloth must remain on the gasket
after the silicone is applied.
CAUTION
4. Wipe out protruded silicone grease form the Rear/RIA
Cover.
To Next Page
Loading...
