Problem solving
The dust extractors T7500/T8600 are designed and manufactured for severe environments and tasks, but the user
must note that the machine components must be protected from knocks and blows. Filter and sealing connections
are carefully chosen for the environment of the operator. Therefore, the machine must be handled with care if it
is to work correctly for many years.
Problem Cause Procedure
Motor does not start No power Connect the machine
Switch defective Change
Motor stops immediately Wrong fuse Connect the correct fuse
Motor runs but there is Hose not connected Connect the hose
no suction Hose blocked Clean the hose
No plastic bag Install plastic bag
Motor runs but suction is poor Damage to the hose Change hose
Blocked filter Change filter
Top cover loose Adjust
Dirt in the flap Clean the flap.
Use protective equipment
Sealing defective Change current seal
Dust blows from motor Defective or loose filter Adjust or change
Abnormal noise Order service
To Next Page
Loading...