3. APPROVALS
The system complies with the requirements of PPE Regulation 2016/425 and European
Standard EN 12941: 1998+A2:2008 class TH3 P R S L. The Respiratory System is de-
equipment can be used in any environment that requires a class TH3P breathing protection
device. It protects against particulate contamination.
All components used in Respiratory System must be ESAB approved parts and must be
used in accordance with the instructions in this manual.
1. The approval is valid only if the product is used together with approved
parts and lters.
2. Only listed particulate lter and pre-lter can be used together with this sys-
tem. Filters from other manufacturers shouldn’t be used under any circumstances,
and voids both the certication and warranty.
4. WARNING AND LIMITATIONS TO USE
Before each use, inspect the Respiratory System for damage and verify it operates properly.
verify it is providing an adequate volume of air.
Continuously wear the Respiratory System and do not remove the helmet or turn OFF the
-
tion of CO
2
and oxygen level in the helmet will fall, resulting in little or no protection.
If you are not sure about the concentration of pollution, or about equipment performance,
consult an industrial safety engineer or EHS manager.
Users of this respiratory device should be properly in its correct wearing and use.
To Next Page
Loading...
Need help?
General
