ADJUSTING THE RINSE AID DISPENSER
→ The rinse aid dispenser has six or four settings. Always start with the dispenser set on
"4". If spots and poor drying are a problem, increase the amount of rinse aid dispensed
by removing the dispenser lid and rotating the dial to "5". If the dishes are still not drying
properly or are showing spots, adjust the dial to the next higher lever until your dishes
are spot-free. The recommended setting is "4". (Factory value is "4".)
→ Increase the dose of rinse aid if there are drops of water or lime spots on the dishes
after washing. Reduce it if there are sticky whitish stains on your dishes or a lm on your
glassware or cutlery.
DETERGENTS
→ Detergents with its chemical ingredients are necessary to remove dirt, crush dirt and
transport it out of the dishwasher. Most of the commercial quality detergents are suitable
for this purpose.
→ If the lid is closed, press the release button and the lid will spring open.
→ Always add the detergent just before starting each wash cycle.
→ Only use branded detergent and rinse aid with your dishwasher.
Warning! Dishwasher detergent is corrosive! Take care to keep it out of reach of
children.
To Next Page
Loading...
