COLD WATER CONNECTION
→ Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
→ If the water pipes are new or have not been used for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the risk
of the water inlet to be blocked and damage the appliance.
CONNECTION OF THE DRAIN HOSE
→ Insert the drain hose into a drain pipe with a minimum diarmeter of 40mm, or connect it
onto the trap of your sink where a dishwasher connection is present.
Important! The top of the hose must be less than 1000mm, as illustrated below.
Note: If you require a longer drain hose, make sure you use a similar drain hose. It must be no
longer than 4 metres; otherwise the performance of the dishwasher will be eected.
LEVELLING THE DISHWASHER
→ Once you have positioned the dishwasher in your desired location, it needs to be levelled
correctly. Using a spirit level, you can wind each of the feet to ensure the dishwasher is
stable and level.
Important! Your dishwasher must be level for it's proper operation and wash performance. Use a
spirit level to ensure this is the case.
To Next Page
Loading...
