The surface of the induction hob may be easily cleaned in the following way:
Type of
contamination
Method of cleaning Cleaning materials
Light Immerse in hot water and
wipe dry
Cleaning sponge
Rings and lime
scale
Apply white vinegar to the
area,wipe with a soft cloth or
use a commercially available
product
Special adhesive for
ceramic glass
Sweetmeat,melted
aluminium or
plastics
Use a special scraper for
ceramic glass to remove
residue（a silicon product is
best）
Special adhesive for
ceramic glass
NB:Disconnect the power supply before cleaning.
8.
Failure display and inspection
If any abnormality occurs,the induction hob will automatically go into protective
mode and display one of the following codes:
Fault Possible cause Solutions
F3-F8 Temperature sensor failure Contact the supplier
F9-FE
Temperature sensor of the IGBT
failure.
Contact the supplier
E1/E2 Abnormal voltage in power
supply
Check if power supply is
normal.
Power on after the power
supply is normal.
E3/E4 Abnormal temperature Check the pan.
E5/E6 Poor heat radiation in cooking
zone
Restart when cooking zone
cools down.
The above table shows how to assess and check common faults.Do not dismantle
the appliance yourself,otherwise you may damage the induction hob.
To Next Page
Loading...