Esperia Xenon E960 - Fully-Charged Battery; Observations; Removing and Repositioning the Battery

85
English
13.5. Remove the battery charger by reversing the previous steps.
13.6. Turn on the bicycle with the controller button on the handlebar.
13.7. Check the LED indicators on the battery and the handlebar controller to conrm
that the battery is charged.
14. Fully-charged battery
14.1. The battery is fully charged when the specic green light is displayed on the
charger.
NOTE: The charging can take 6-8 hours, depending on the residual charge level in
the battery.
14.2. Disconnect the battery charger plug from the 220V power socket.
14.3. Remove the second plug of the battery charger from the battery connector.
14.4. If removed from its housing, reposition the battery in the appropriate bicycle
housing and ensure it is well placed on the bottom.
15. Removing and repositioning the battery
15.1. Insert the key into the appropriate lock on the side of the bicycle.
15.2. Rotate the key 180°, remove the cover and remove the battery.
16. Observations
16.1. This battery model cannot be used with other models. Avoid using the same battery
for different bicycles.
16.2. Even if compatible, never use other non-original batteries.
16.3. For safety reasons, the bicycle electrical system is equipped with a special fuse that
protects all electronic instrumentation from any power surges.
ATTENTION: Do not open the battery to replace the fuse. This would entail cancellation of
the warranty terms.Contact your dealer.