Specific Safety Rules
- Thoroughly inspect the working area, keep the area clean and free of debris to prevent
tripping. Operate on a flat level ground.
- Never place any part of your body where it would be in danger if movement should occur
during assembly, installation, and operation, maintenance, repairing or moving.
- Keep all bystanders, children, and pets at least 23 m away. If someone approaches you,
stop the unit immediately.
- Do not mount anything on the dump box and never carry passengers
- Never park the machine in a place with unstable ground, which could give way,
particularly when the dumper is full.
- Disengage the clutch lever before starting the engine.
- Start the engine carefully according to instructions and with feet away from the moving
parts.
- Never leave the operating position when the engine is running.
- Always hold the unit with both hands when operating. Keep a firm grip on the handlebars.
Be aware that the machine may unexpectedly bounce upward or jump forward if the
machine should strike buried obstacles such as large rocks or roots.
- Walk, never run with the machine.
- Do not overload the machine capacity. Drive at a safe speed, adjusting the speed to the
slope of the land, the surface conditions of the road and the weight of the load.
- Use extreme caution when in reverse or pulling the machine towards you.
- Exercise extreme caution when operating on or crossing gravel drives, walks, or roads.
Stay alert for hidden hazards or traffic.
- On soft ground, drive at the first forward/reverse gear. Do not rapidly accelerate, turn
sharply or stop.
- Pay the utmost attention when working on frozen ground as the machine may tend to
skid.
- Do not operate the machine in confined areas where there may be a risk of crushing the
operator between the machine and another object.
- Never operate the machine on slopes where with an angle of over 20°.
- When operating on a slope, whether moving forward or in reverse, always make certain
that the weight is evenly balanced. Always move in directions parallel with the slope. Do
not shift gears on slopes.
- When dumping the contents of the hopper, the center of gravity will change continuously
and the ground conditions will be essential for the stability of the machine. Use extra
caution and control when dumping the hopper on e.g. wet clay.
To Next Page
Loading...