Espina XTP131 - User Manual

Questions and Answers

C
Cynthia MartinAug 7, 2025
Why won't my Espina Construction Equipment engine start?
- E
  Eric GonzalezAug 8, 2025
  If your Espina Construction Equipment engine won't start, several factors could be at play. First, make sure the spark plug wire is securely attached to the spark plug. If that's not the issue, check your fuel: ensure you have clean, fresh gasoline. For a cold start, the throttle must be positioned at choke. Other potential causes include a blocked fuel line (which you should clean), a fouled spark plug (clean, adjust the gap, or replace it), or engine flooding (wait a few minutes to restart, without priming).
D
David BridgesAug 14, 2025
What to do if my Espina Construction Equipment engine runs erratically?
- S
  swansonkimAug 14, 2025
  If your Espina Construction Equipment engine runs erratically, start by checking the spark plug wire to ensure it's connected and tight. Make sure that the unit is not running on CHOKE, so move the choke lever to OFF. A blocked fuel line or stale fuel could also be the culprit; clean the fuel line and fill the tank with clean, fresh gasoline. Additionally, check for a plugged vent and clear it. If there's water or dirt in the fuel system, drain the fuel tank and refill with fresh fuel. A dirty air cleaner can also cause issues, so clean or replace it. If none of these steps resolve the issue, the carburetor adjustment may be improper, and you should refer to the engine manual.
J
Joseph MillerAug 19, 2025
Why does my Espina XTP131 engine overheat?
- D
  Derrick HamiltonAug 19, 2025
  If your Espina Construction Equipment engine overheats, begin by checking the engine oil level and fill the crankcase with the proper oil if it's low. A dirty air cleaner can also cause overheating, so clean the air cleaner. Additionally, check for restricted airflow and remove the housing to clean any obstructions. If the issue persists, the carburetor may not be adjusted properly, and you should refer to the engine manual.
J
Julia WilcoxAug 26, 2025
What to do if my Espina Construction Equipment machine does not move?
- P
  pereztiffanyAug 26, 2025
  If your Espina Construction Equipment machine doesn't move while the engine is running, check the gear selection. Ensure the gear lever is not positioned in-between two different gears. Also, verify that the driving tracks are tight enough and tighten them if necessary.
C
Curtis BrownAug 31, 2025
How to unblock Espina XTP131 track?
- J
  jeremy69Sep 1, 2025
  If one of the two tracks on your Espina Construction Equipment is blocked, it's likely that foreign bodies have found their way between the track and the frame. Remove the foreign body to resolve the issue.