CANOPY: ASSEMBLY AND OPERATION
13. Assemble the endirlals of the canopy on the plastic elements of the guide bar
andattach the canopy to the upholstery with snap fasteners.
14. To change the position of the canopy, hold its top part and adjust it to the
requiredposition.
HANDLE ADJUSTMENT
15. Simultaneously press both buttons on both sides of thehandle and adjust it to the
required position.
BACKREST ADJUSTMENT
16. To lift the backrest, hold the belt of the adjusting mechanism (1) and push the
backrestto the required position (2)
17. To lower the backrest, press the button of the adjusting mechanism (1)
andsimultaneously lower the backrest to the required position (2).
18. PARKING DEVICE (brake)
Press the brake pedal with the foot to lock the rear wheels. Lift the brake pedal with thefoot
to unlock the rear wheels.
FOLDING THE STROLLER
19. Unlock the front wheels, lower the backrest and fold the canopy.Move the locking
mechanism of the folding button to the right (1) and press the foldingmechanism of the
stroller (2). Push the handle forward at the same time (3).
20. Make sure that the locking mechanism secured the stroller against accidentalunfolding.
SHOULDER STRAPS LENGTH ADJUSTMENT
21. Pull out the free end of the strap to remove any loose part.
22. Pull the fastener (2) to loosen the tension of the shoulder straps. Adjust the length of the
hips and crotch straps using the fasteners (3)
BUCKLE MANUAL
23. The stroller is equipped with a magnetic buckle. To unbuckle the buckle, press both
buttons of the buckle located on both sides at the same time and remove one part from the
other one.
HOW TO LOCK THE BUCKLE
24. Insert the strap fastening mechanism in the back part of the buckle. Repeat
on the other side.
25. Attach two parts of the buckle with one other.
26. Attach the front part of the buckle with the back part until you hear the clicking sound.
Check if the buckle is properly locked in place.
ASSEMBLY / ADJUSTMENT OF THE SAFETY BELTS HEIGHT
27. To assemble / To adjust the height of the seat belts, take them out of the openings in
thebackrest/seat unit and the upholstery and insert through openings in the upholstery andthe
seat unit/backrest at the desired height.
NOTE! Before locking the child with the seat belts, make sure that the seat belts areproperly
assembled.
28. In case of use of additional harness, mount them to the harness attachment points,located
on both sides of seat rest
29. FOOTMUFF
Insert the footmuff on the footrest and fix it with snap fasteners placing it upper part
overthe bumper bar.
To Next Page
Loading...
