PROGRAMMING VIA SMS (ONLY WITH GSM200) Page 26
DTv: : string setting acknowledge (v = setting)
OP : programming exit acknowledge (Out Prog).
In case a telephone number has been programmed, the string setting will have
the following format:
DTaNbNy…y
Where:
a: source
b: receiver
y…y: telephone number
In case a wrong setting has been entered , the acknowledge string ER will be
returned.
In case the password is wrong , you will receive the acknowledge string RL ER
followed by as many ER as the sent codes are.
Remark: settings may be displayed fully or partially in the
acknowledge SMS returned after programming, depending on
the characteristics of the SMS recipient devices.
Examples
Desired settings:
- date: Thursday 04/02/16
- hour: 21.15
- automatic test call: enabled
Programming message:
ET-HL3 *0# 364040216 352115 341
Notification message:
IP DT4040216 DT2115 DT1 OP
Desired settings:
- phone number 0717506066 in the first location associated with Emergency
call (source) under User mode (receiver)
- phone number 0717506105 in the second location associated with Automatic
test call (source) under Esse-ti protocol mode (recipient)
Programming message:
ET-HL3 *0# 2101120717506066# 2102330717506105#
Notification message:
IP DT1N2N0717506066 DT3N3N0717506105 OP
To Next Page
Loading...
