The washing machine should be
connected to the water mains via the
new tube supplied with the
appliance (inside the drum). Do not
use the old tube for this purpose.
Connect one end of the water inlet
pipe with the elbow bend to the
electrovalve (top rear part of the
machine) and the o
or a plumbed-
connection.
Place the washing machine close to
the wall, ensuring that there are no
bends or kinks anywhere in the tube.
Hook the outlet pipe to the edge of
the sink or preferably to a fixed
drainage outlet of a diameter greater
than that of the outlet pipe and at a
height of min. 50 cm. and a
maximum of 75 cm. from the floor
(
fig. 4
).
If necessary, use the curved*
accessory to attach and support
the outlet pipe more securely.
offers this function:
To move the washing machine
easily, turn the trolley lever to the
right. Once you have finished
moving the machine, return the lever
to its original position.
Level the machine by adjusting the
front feet (
fig. 5
).
a) Turn the nut c
the screw on the foot.
b) Raise or lower the foot by rotating
it until it stands firmly on the floor.
c) Lock the foot in position by turning
the nut anticlockwise until it comes
up against the bottom of the
washing machine.
Check that the appliance is properly
levelled.
Check that the washing machine
does not rock by trying to move two
diagonally opposite top corners at
the same time.
If you move the washing machine
from one place to another, you must
level the feet again afterwards.
To Next Page
Loading...
Need help?
General