Error codes
When the system encounters an error, the display will show an error code. As soon as the problem is fixed
the error code will reset.
Error codes
Check the connection in your rear
motor cable. The rear motor cable
runs underneath the frame on the lhs
near the stand. If necessary unplug the
cable, ensure it is clean and free from
corrosion. Plug in the cable and try
again.
Check the cable connections
underneath your handlebar. If they
have become loose, please align the
arrows and reconnect the cable.
Check the brake lever is not applied
and the brakes have been correctly
adjusted.
Check if the display and controller are
connected properly
Wire Sequences
Terminal Male Connector Female Connector
To Next Page
Loading...
