EasyManua.ls Logo

Estes Proto X User Manual

Estes Proto X
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
FCC STATEMENT AND INDUSTRY CANADA NOTICE:
1. This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Remark: This device is in accordance with the digital device grade B limitation and the
15th regulation of FCC. This limitation requires reasonable anti-interference protection
around the residence. The device can transmit radio wave during use and can interrupt
the mobile communication without proper installment. Interruption will occur for special
device. If the device do interrupt the radio or television, please turn the device off then turn
it on to adjust. Below are some resolution for your reference:
Move the receiving antenna
Enlarge the distance between the device and receiver
Try to not connect the device and the receiver on the same circuit
Ask for professional help from experts
3. This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus set out in the Radio Interference Regulations of Industry Canada.
4606
Estes-Cox Corp.
1295 H Street, PO Box 227
Penrose, CO 81240-0227
Made In Dongguan, Guangdong,
China
Do not turn on Proto X unless controller has been turned on fi rst.
Keep hands, hair and loose clothing away from spinning blades.
Turn off controller and Proto X when not in use.
Parental guidance is recommended.
Do not submerge into water. This could damage electronic assemblies.
Follow operating instructions exactly.
Not intended for children under 8 years old.
Replace any damaged or broken parts before attempting to fl y.
Do not drop the Proto X by suddenly reducing the throttle. This could
lead to severe damage.
The Proto X’s range will also be affected if the battery is not fully
charged.
Do not touch the motors after fl ying. They can become hot.
CAUTION: Changes or modifi cations to
this product not expressly approved by
the party responsible for compliance may
void the user’s authority to operate the
equipment.
90 DAY LIMITED WARRANTY
PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE – Estes will repair or replace factory defects for 90 days from the date of purchase. This warranty
specifi cally does not cover crash damage, misuse or abuse. To make a warranty claim, please contact our product support team at 1-217-398-8970 or
e-mail us at productsupport@hobbico.com
If requested by Product Support, please send defective product to: Hobby Services, 3002 N Apollo Dr., Suite #1, Champaign, IL 61822
This warranty applies only if the product is operated in compliance with the instructions and warnings provided with each model. Estes assumes no liability except for
the exclusive remedy or repair of parts as specifi ed above. Estes shall not be liable for consequential or incidental damages. Some states do not allow the exclusion
of consequential or incidental damages so the above exclusion may not apply to you. This warranty gives you specifi c legal rights and you may also have other rights
which vary from state to state.
Battery Requirements for Controller:
Requires: 2 x 1.5V AAA size batteries (not included)
Requirements for USB Charge Cord:
USB Output Jack (not included)
Battery Cautions:
Parental guidance is recommended when installing batteries.
Do not power controller by mixing different types of batteries, or old and new batteries.
Use only batteries of the same or equivalent type as those recommended.
The Proto X is equipped with a rechargeable 3.7V LiPo battery.
Please pay attention to the following cautions for safe use:
Do not dispose of battery into fi re or heat.
Do not use or leave battery near a heat source, such as fi re or a heater.
Do not strike battery or throw it against a hard surface.
Do not pierce battery.
Do not disassemble or alter battery.
Turn off power switch after use.
Recycle used batteries.
Contents
Do not touch the
spinning blades or
y over another person’s
head. Adult supervision is
required.
12
ON OFF
3 4 5
GET READY TO FLY
Plug the charger into a USB port and
quad as shown. (The battery connector
will only fi t in one way. Do not force the
connectors together.)
The red LED will light when charging.
The red LED will shut off once the
charge is complete.
Set the Proto X on a level surface until the
blue LEDs change from blinking to solid.
Switch on controller.
LED
Off
On
NEVER leave the Proto X unattended when charging.
DO NOT allow the USB port to power down when
connected to the ProtoX.
ALWAYS unplug the ProtoX when charging is
complete.
Question and Answer IconNeed help?

Do you have a question about the Estes Proto X and is the answer not in the manual?

Estes Proto X Specifications

General IconGeneral
Flight Time6-8 minutes
Charging Time20-30 minutes
Transmitter2.4GHz
Skill LevelBeginner
Indoor/OutdoorIndoor
Channels4
LED LightsYes
Battery3.7V LiPo

Summary

FCC Statement and Industry Canada Notice

Device Compliance and Conditions

Device complies with FCC Part 15 and Industry Canada RSS-210, subject to interference conditions.

Modifications and User Authority

Unauthorized modifications void the user's authority to operate the equipment.

Digital Apparatus Radio Noise Limits

Digital apparatus adheres to Class B limits for radio noise emissions per Industry Canada regulations.

Safety Precautions and Battery Handling

General Operational Safety

Keep clear of blades, turn off when not in use, parental guidance recommended, and not for children under 8.

Environmental and Handling Warnings

Do not submerge in water, replace damaged parts, avoid sudden throttle reduction, and avoid hot motors.

Controller Battery Requirements

Requires 2 x 1.5V AAA batteries (not included); use same type and do not mix old/new.

LiPo Battery Safety Cautions

Do not dispose in fire, avoid heat, do not pierce or alter, and turn off after use.

Getting Ready to Fly

Charging the Proto X

Connect to USB, red LED indicates charging; shuts off when complete. Never leave unattended.

Pre-Flight Setup

Place Proto X on a level surface until blue LEDs change from blinking to solid.

Flight Operations and Maintenance

How to Fly Controls

Explains basic flight controls: UP, DOWN, FORWARD, BACKWARD, ROTATE LEFT/RIGHT, LEFT/RIGHT.

Correcting Flight Drift

Use trim buttons opposite the movement direction to eliminate consistent drift.

Replacement Blades

Identifies front (Gray Blades, Blue LEDs) and rear (Black Blades, Red LEDs) blade locations.

Landing Safely

Land when LEDs flash, indicating low battery voltage to avoid power cut-off.

Linking the Transmitter

Hold throttle down, turn on controller, wait for red LED to turn green.

Troubleshooting Common Issues

Addresses controller linking, flashing LEDs, shaking, and takeoff problems.

Related product manuals