Et BLUE-ROLL User Manual

1
ET BLUE-ROLL
Domestic type roll-up garage door operator
Installation manual
Revision Oct.08.002
support@et.co.za
Technical specifications may change without prior notice.
All goods are subject to the standard factory warranty as laid out on the last page of this publication
G&C Electronics cc. T/A ET Systems
15 Nelson Rd, Observatory, Cape Town, South Africa
www.et.co.za

Et BLUE-ROLL Specifications

General

Model	BLUE-ROLL
Category	Garage Door Opener
Remote Control	Yes
Safety Sensors	Yes
Safety Beam Input	Yes
Courtesy Light	Yes
Remote Control Frequency	433MHz
IP Rating	IP44
Operating Temperature	-20°C to +50°C
Motor Type	DC

Summary

PRE-INSTALLATION INSTRUCTIONS

1. PRE-INSTALLATION PREPARATION

Essential checks and measurements before installing the garage door opener.

INSTALLATION INSTRUCTIONS

2. INSTALLING THE OPENER ONTO THE DOOR SHAFT

Step-by-step guide for mounting the opener onto the door shaft.

PIN DOOR CURTAIN TO DOOR DRUM WHEEL

3.1 Pinning the door curtain to the drum wheel

Securing the door curtain to the drum wheel to prevent forced lifting.

WEIGHT BARS (Optional – not supplied)

4.1 Weight bars may be required

Purpose and fitting of optional weight bars for door curtain ballooning.

CONTROL CARD FEATURES AND SETUP EXPANDED

A. Auto-close link

Configuration of automatic closing timer and beep warnings.

B. Receiver programming pins

Procedures for master erasing and programming new transmitters.

C. RX detection L.E.D.

Function of the receiver detection LED and its use in programming.

D. Test Button

Operation of the onboard test button for door activation.

E. AC supply Fuse

Fuse replacement guidelines for AC supply protection.

F. Load sensing P.O.T

Adjusting obstruction sensitivity for safety reverse function.

G. Charger Voltage P.O.T

Factory preset for charger voltage and current limits.

H. Motor output fuse

Fuse replacement guidelines for motor power supply protection.

I. Battery low beep override jumper

Configuring battery low beep behavior when batteries are installed.

7.1 Adding remotes via an existing remote

Process for adding new remotes using an existing programmed remote.

7.2 Remote controlled holiday lock-out

Feature to disable remotes for security, like during holidays.

Adjusting the open and closed limit positions

SETTING THE DOOR TRAVEL LIMITS

Procedure for setting the open and closed travel limits for the door.

8.1 Open Limit

Manually setting the door's fully open position.

8.2 Closed Limit

Manually setting the door's fully closed position.

GENERAL MAINTENANCE

10 The following should be conducted MONTHLY

Routine monthly maintenance checks for safety and operation.

11 We recommend the following service to be carried out ONCE A YEAR

Annual recommended professional service for the garage door opener.

HOW TO REPLACE THE COURTESY LIGHT BULB

Instructions for replacing the courtesy light bulb.