eta 355490000 User Manual (English)

Questions and Answers:

T
Todd TaylorAug 17, 2025
Why eta 355490000 machine does not start?
- S
  Steven MendozaAug 17, 2025
  Your eta Washer might not start due to several reasons: * It might not be plugged in, so ensure it is properly connected. * The fuses could be faulty, requiring replacement. * There might be no mains power supply, so check the power. * The Start/Pause button may not have been pressed; press it to start. * The program dial could be in the 'stop' position; turn it to the desired program. * The machine door may not be completely closed; ensure it is securely closed.
E
Erin BarnesAug 19, 2025
What to do if eta Washer machine does not intake water?
- L
  Luis ContrerasAug 20, 2025
  If your eta Washer isn't taking in water, consider these possibilities: * The water tap might be off; turn it on. * The water inlet hose could be twisted; check and untwist it. * The water inlet hose might be clogged; clean the filters. * The inlet filter itself could be clogged; clean it. * The machine door may not be completely closed; ensure it is closed properly.
E
Ernest HarperAug 22, 2025
What to do if eta 355490000 Washer machine vibrates?
- A
  Aaron NavarroAug 22, 2025
  If your eta Washer is vibrating, here's what might be happening: * The feet may not be adjusted; adjust them for stability. * Transit bolts used for transportation might still be attached; remove them. * A small load in the drum can cause vibration, but it shouldn't prevent operation. * The machine might be overloaded or the laundry is unevenly spread; avoid overloading and spread laundry evenly. * The washer could be on a hard surface; avoid placing it on hard surfaces.
C
Craig BarnesAug 25, 2025
What to do if eta 355490000 machine does not discharge water?
- S
  Samuel GillAug 26, 2025
  If your eta Washer isn't discharging water, check the following: * The drain hose could be clogged or twisted; inspect, clean, or untwist it. * The pump filter might be clogged; clean the pump filter. * Laundry might be too tightly packed; spread your laundry evenly in the machine.
A
alexandersimmonsAug 28, 2025
Why does eta 355490000 Washer laundry have detergent residue?
- T
  Terry HernandezAug 28, 2025
  If your laundry has detergent residue, it may be due to non-dissolving particles of some detergents appearing as white spots. To resolve this, perform an extra rinse or clean your laundry with a brush after it dries.
A
Andrew SandersAug 31, 2025
Why is there excessive foam in eta Washer detergent drawer?
- C
  clinton10Aug 31, 2025
  Excessive foam in the detergent drawer of your eta Washer can occur if you've used too much or the wrong detergent. To stop the foam, press the Start/Pause button, dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer. Press the Start/Pause button after 5-10 mins. Only use detergents produced for automatic Washing Machines.
T
Tracy WatsonSep 2, 2025
Why is eta Washer washing result unsatisfactory?
- T
  Teresa RiveraSep 2, 2025
  An unsatisfactory washing result from your eta Washer could be due to several reasons: * Your washing might be too dirty for the selected program; select a more appropriate program. * The amount of detergent used might be insufficient; use the amount of detergent as instructed on the packaging. * There might be too much laundry in your machine; check that the maximum capacity for the selected program has not been exceeded.
B
Benjamin JohnsonSep 5, 2025
Why is eta 355490000 washing result unsatisfactory because of hard water?
- A
  Amy FloresSep 5, 2025
  If you're getting unsatisfactory washing results from your eta Washer and you have hard water, increase the amount of detergent following the manufacturer’s instructions. Also, ensure that your laundry is spread out in the drum.
E
Erica PriceSep 8, 2025
Why does eta 355490000 spin cycle take place later than expected?
- G
  Gina ThomasSep 8, 2025
  If the spin cycle in your eta Washer does not take place or takes place later than expected, it is likely not a fault. The Unbalanced load control system has been activated. This system will try to spread your laundry, and the spinning cycle will begin once your laundry is spread. For the next wash, load the drum evenly.
A
Alexis HarrisSep 12, 2025
Why does eta 355490000 Washer discharge water as soon as it is loaded?
- A
  Adam ThomasSep 12, 2025
  If your eta Washer discharges water as soon as it's loaded, it's likely because the end of the water drain hose is too low. Check that the drain hose is at a suitable height.